Step 1: Pre-Installation
- Pack the following equipment to use onsite:
- Wireless Keyboard & Mouse (with a single USB receiver)
OR,
Wired Keyboard - Screwdriver
- Wireless Keyboard & Mouse (with a single USB receiver)
- Power & Network Connection - Important:
- Wiring - If electrical and/or network wiring is required, please contact your preferred, registered electrician.
- Power
- Ideally, the screen will be mounted over or near the power point
- Please organise capping if running an extension cord to the nearest power outlet.
- Network
- Ensure that a network connection is set up prior to going onsite so you can connect your large format display to the network once mounted. We recommend using a fixed/wired connection. Failing that, a strong, secure, public wireless connection is required.
- If using a wireless connection,
- Ensure that the signal strength is 60% or higher
- Check the network/firewall settings and contact support@labyrinth.co.nz to confirm the server IP address if whitelisting is required to ensure open communication with the app and our servers.
- If the wireless connection has a browser prompt, please ask the IT team to remove the prompt
Step 2: On-site Installation:
- Mount Screen
Position the screen in the best viewable area and ensure that the screen covers the power outlets. Make sure the screen is not alongside a window with direct sunlight or is in a location that will get direct sunlight. If you have any concern, please contact our support team on 09 415 9301. - Locate the Digital Signage app or Vibe Browser app for your large format display or device
Note: Before you leave the site
- Ensure that cables are hidden (using capping or tucked behind the screen)
- Take high-res photos of the finish mounted screen to provide us for our records
- Wide view to clearly show your wonderful installation of the screen in its location
- Screen close-ups. Front-on and from an angle
- Make sure the screen is turned on and showing digital signage content onscreen
- No people in the photos
- Leave the screen on
- Leave the remote control with the primary onsite contact. Do not leave with the TV as staff may turn the screen off.
- Remove or take any packaging with you
- Notify the Labyrinth project manager (project@labyrinth.co.nz / Trello) or contact support@labryrinth.co.nz to advise that the screen setup is complete
Example Installation Photos
Comments
0 comments
Please sign in to leave a comment.